Page 1 of 1

How to change Boot Parameters

PostPosted: Sun Feb 04, 2018 12:36 am
by wjohnson133
I am trying to install Vicibox on a HP Proliant DL380 G5 with a RAID hard drive that uses a CCISS driver that is very old. I was able to install CENTOS 7 on it by changing the boot parameters hpsa.hpsa_simple_mode=1 hpsa.hpsa_allow_any=1

I was wondering if anybody could explain how I could customize the install parameters to include this so as to get the installation to see my hard drive?

Re: How to change Boot Parameters

PostPosted: Sun Feb 04, 2018 12:06 pm
by williamconley
RAID often has a "boot HD" configuration setting. That HD is the only one that can provide boot sector.

But Vicibox will install boot sector information on whichever HD it perceives as "first drive", which may NOT be the HD that the RAID will expose as "boot HD". Thus you can have a boot sector in a HD that will not be available until after the boot sector has done it's job.

When you first install, use only a single HD configured by RAID which must also be the one marked as Bootable in RAID. This will ensure that the RAID and Vicidial are in agreement where the boot sector is (on that single HD). After your primary OS installation is completed, you can then add new HDs and none of the boot sector information will be moved to it, as you are merely adding a new HD and not re-installing an OS.

Alternately, you can tell Vicibox to install the boot information on the HD instead of the Master Boot Sector.