Clustering

Any and all non-support discussions

Moderators: gerski, enjay, williamconley, Op3r, Staydog, gardo, mflorell, MJCoate, mcargile, Kumba, Michael_N

Clustering

Postby Zaraab » Wed May 05, 2021 11:03 am

Can somebody please explain or enlighten me about the purpose of clustering? Say as I have 3 servers web/db/Asterisk.

Each of 2 core cpu, 2gb ram and 1tb harddisk. So what if i just use a octa core processor or core i7 and 8gb ram and 2tb haddisk instead of separate servers?

Your reply might be that clustering will balance the load. But i would like to hear more.
A VICIDIAL ENTHUSIAST
OS BASED LEARNING : CentOS - openSUSE
INSTALLATION METHODS : MOSTLY SCRATCH & STD INSTALLATION WITH .ISO
HELP - BELIEVE - INNOVATE
Zaraab
 
Posts: 151
Joined: Fri May 22, 2020 1:21 pm

Re: Clustering

Postby dhijrwn » Wed May 05, 2021 1:11 pm

Zaraab wrote:Can somebody please explain or enlighten me about the purpose of clustering? Say as I have 3 servers web/db/Asterisk.

Each of 2 core cpu, 2gb ram and 1tb harddisk. So what if i just use a octa core processor or core i7 and 8gb ram and 2tb haddisk instead of separate servers?

Your reply might be that clustering will balance the load. But i would like to hear more.

The primary reason to do load balancing, or clustering of multiple VICIDIAL servers, is to spread the calls taken in or the answered calls on an outbound campaign across all of the agents that are logged into a campaign no matter what server they are on. For instance, on an outbound campaign, you have 2 servers, server one has 20 agents logged in on a campaign and the other server(two) has 5 agents logged in on the same campaign. Lets say that the campaign is set to a dial_level of 3.0 so there are 60 active calls being placed on server one and 15 active calls being placed on server two. Then 23 of the calls on server one answer, meaning that there are three calls too many for the agents available on that server. Under a load-balancing-overflow setup, those three calls can travel over an IAX2 trunk directly to the agents on that server that are still available. This increased efficiency in both inbound and outbound environments as well as reducing on-hold times for customers and equalizing wait times for agents across all servers for a campaign.

Another reason for load balancing is the ability to use cheaper hardware on the server side. It is much cheaper and more fault-tolerant to buy four P4 2.0GHz 1U servers for $800 a piece than it is to buy a single 4U quad Xeon 3.2GHz server. The four 1U servers will have more total capacity, can be easily scaled and if one fails you've only lost 25% of capacity instead of everything. This philosophy has serverd our call center very well over the last two years.

Check the official docs here http://vicidial.org/docs/LOAD_BALANCING.txt
Last edited by dhijrwn on Thu May 06, 2021 2:50 am, edited 1 time in total.
Cluster setup i7-9700 cpu @ 3.00ghz 32GB ram 1xDB WEB ARCH 11xTEL 4core
ViciBox v.9.0.3 ISO VERSION:2.14-853a BUILD: 220328-1420
SVN: 3595 DB Schema: 1657 | Asterisk 13.29.2-vici
Zoiper 5 | VICIPhone| No Digium/Sangoma Hardware
dhijrwn
 
Posts: 149
Joined: Tue Jan 07, 2020 6:12 am

Re: Clustering

Postby Zaraab » Wed May 05, 2021 10:42 pm

Amazing explanation. Thank you so much dhijrwn!

I was thinking of that if the clustering could act like back up for pc outage or server crash. So maybe if there was something like that and we had 2 servers. then if 1 of them would have died, the other standby on could take over and get go.
A VICIDIAL ENTHUSIAST
OS BASED LEARNING : CentOS - openSUSE
INSTALLATION METHODS : MOSTLY SCRATCH & STD INSTALLATION WITH .ISO
HELP - BELIEVE - INNOVATE
Zaraab
 
Posts: 151
Joined: Fri May 22, 2020 1:21 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 49 guests