audio glitch via nat

Any and all non-support discussions

Moderators: gerski, enjay, williamconley, Op3r, Staydog, gardo, mflorell, MJCoate, mcargile, Kumba, Michael_N

audio glitch via nat

Postby liigi » Thu Oct 14, 2021 8:19 am

Hello everyone, I come here to help me with this problem.I have two sites interconnected with each other through a vpn with nat, in both connections it has nat


SITE 1

VERSION: 2.14-769a
BUILD: 200916-0922
ASTERISK 13.21.1-vici
Version: 2.14b0.5
SVN Version: 3298
DB Schema Version: 1606
LAN :192.168.0.9
NAT: 192.168.20.9


SITE2 :
VERSION: 2.14-763a
BUILD: 200719-1645
SVN Version: 3271
DB Schema Version: 1602
ASTERISK :13.34.0-vici
LAN :172.16.20.40
NAT: 172.16.30.40


But i dont have audio , any audio . if i call ext between servers , the call complete but have not audio.It is obvious a communication problem because the nat, but I am a newbie .

when I do packet capture the packets go to the LAN IP but the rtp packets go to the NAT IP
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm

Re: audio glitch via nat

Postby ambiorixg12 » Thu Oct 14, 2021 1:12 pm

Verify that the media address is correct and also the contact header using sip set debug on

Check the media flow with rtp set debug on
ambiorixg12
 
Posts: 448
Joined: Tue Sep 17, 2013 10:35 pm

Re: audio glitch via nat

Postby Rogger » Fri Oct 15, 2021 8:45 am

Hi,

Use sngrep and look at the route table.

Good luck
Rogger
 
Posts: 41
Joined: Fri Nov 27, 2015 9:53 am
Location: Brazil

Re: audio glitch via nat

Postby liigi » Fri Oct 15, 2021 9:09 am

192.168.0.9___________ 172.16.30.40 _____________172.16.20.40
5060 --------------------------------> SIP INVITE
5060 <------------------------------- SIP STATUS 100
5060 <------------------------------- SIP STATUS 200
5060 -------------------------------> SIP INVITE ACK 200
14186 ------------------------------------------------------------> RTP (HERE IS THE PROBLEM RTP GO TO LAN NOT TO NAT IP )
5060 -------------------------------> BYE
5060 <------------------------------- SIP STATUS 200 OK


This is flow sequense form site 1 , it is possible that if I check the sequence from site two I will see the same problem since I use nat on both sites

How can I make the rtp packets go to the nat ip (the nat is done by my firewall, it is responsible for making the transfer of the ip with nat to the lan ip)
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm

Re: audio glitch via nat

Postby ambiorixg12 » Sun Oct 17, 2021 4:05 pm

Make sure you have the correct NAT settings using the sip show settings command, settings should look like this

nat=rtp_force,comedia
directmedia=no
localnet=192.168.0.0/255.255.0.0 ;( chante this by your localnet)
externip=public ip
ambiorixg12
 
Posts: 448
Joined: Tue Sep 17, 2013 10:35 pm

Re: audio glitch via nat

Postby liigi » Mon Oct 18, 2021 8:04 am

Hi pall
My sip .conf have de localnet and the public ip set .The nat that I am doing is between sites on my network, it does not go to the public network.
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm

Re: audio glitch via nat

Postby liigi » Mon Oct 18, 2021 1:05 pm

I think i can solve the problem using IAX trunk insted of SIP .But i recive this error


[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: Rx-Frame Retry[ No] -- OSeqno: 001 ISeqno: 001 Type: IAX Subclass: REGREQ
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: Timestamp: 00009ms SCall: 00754 DCall: 11984 172.16.30.40:4569
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: USERNAME : myuser
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: REFRESH : 60
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: PASSWORD : Mypass
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c:
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: Tx-Frame Retry[-01] -- OSeqno: 001 ISeqno: 002 Type: IAX Subclass: ACK
[Oct 18 14:01:10] VERBOSE[2258] chan_iax2.c: Timestamp: 00009ms SCall: 11984 DCall: 00754 172.16.30.40:4569
[Oct 18 14:01:11] VERBOSE[2226] chan_iax2.c: Tx-Frame Retry[000] -- OSeqno: 001 ISeqno: 002 Type: IAX Subclass: REGREJ
[Oct 18 14:01:11] VERBOSE[2226] chan_iax2.c: Timestamp: 01003ms SCall: 11984 DCall: 00754 172.16.30.41:4569
[Oct 18 14:01:11] VERBOSE[2226] chan_iax2.c: CAUSE : Registration Refused
[Oct 18 14:01:11] VERBOSE[2226] chan_iax2.c: CAUSE CODE : 29

i only create a iax trunk (mimic preexisten vicidial iax trunk)
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm

Re: audio glitch via nat

Postby liigi » Mon Oct 18, 2021 1:28 pm

This is my trunk
register => miuser:mipass@172.16.30.41

[IAXPLAZA]
accountcode=miuser
secret=mipass
type=friend
requirecalltoken=no
context=default
auth=plaintext
host=dynamic
permit=0.0.0.0/0.0.0.0
disallow=all
allow=ulaw
qualify=yes
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm

Re: audio glitch via nat

Postby ambiorixg12 » Mon Oct 18, 2021 2:17 pm

If those 2 boxes have static IP and you know them, you don't need to use registration. I have a while I don't use IAX2 but this setting should work

https://asterisk-rd.blogspot.com/2015/1 ... -iax2.html
ambiorixg12
 
Posts: 448
Joined: Tue Sep 17, 2013 10:35 pm

Re: audio glitch via nat

Postby liigi » Tue Oct 19, 2021 9:57 am

thanks u that work , but now a have a error cause 50 in the dial

[IAXAUTANA]
username=1005
secret=1010
host=172.16.30.40
type=friend
context=trunkinbound
qualify=yes
qualifyfreqok=25000
trunk=yes
forceencryption=no
encryption=yes
auth=md5
requirecalltoken=no

exten => _78.,1,AGI(agi://127.0.0.1:4577/call_log)
exten => _78.,2,Dial(${IAXTRUNK}/${EXTEN:2},,To)
exten => _78.,3,Hangup
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm

Re: audio glitch via nat

Postby liigi » Tue Oct 19, 2021 11:20 am

Thanks I did it like you without problems thanks u. The NAT problem was resolved with an iax trunk
:lol: :lol: :lol: :lol:
liigi
 
Posts: 70
Joined: Wed Jul 13, 2016 4:39 pm


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 33 guests